Setting up your new Dnoodle drink holder is easy.

First, choose a sealed, flat, hard surface. Remember, this installation is permanent, so make sure that’s where you want it.

Clean the surface with the included alcohol wipe.

Peel the backing tape off the red Dnoodle base, and place it tape-side down on your location with the Dnoodle logo facing you in the direction of use. Firmly apply downward pressure for 30 seconds.

Next, place the blue cup component on the red Dnoodle base. It will be locked on and difficult to remove, until the cup or device is attached.

Choose the solid flat-based cup or device you want to use with the Dnoodle and repeat the cleaning and preparation steps with the bottom of your cup or device.

Remove the backing tape from the blue cup component and make sure it is lined up in the orientation you want it. This step is especially important with drinkware with a handle. Firmly press the cup or device onto the cup component for 30 seconds with downward pressure. Take care with devices and do not push directly on screens as this could lead to damage.

Now remove the cup or device with an upward twisting motion of 90 degrees in either direction. When placing the cup or device, slide the blue component over the red base, and you will feel a guided tactile response to let you know it is locked on.

To remove the Dnoodle drink holder, use some fishing line and run it underneath the base while gently prying upward. This can take some work. Residual tape residue can be rolled off with fingers or some sticky residue remover. When using residue remover, test it in an inconspicuous area first to ensure it doesn’t discolor or damage the finish. Avoid using sharp utensils as it may lead to damage or injury.

Follow a similar process to remove the cup component from your cup. Only follow this process when you’re done with your Dnoodle.

We’ll be offering replacement tapes soon, so you can keep your Dnoodle locked down and ready for more adventures.